Documentation Wiki rss-feed

MIDI Input Configuration


If you have external hardware MIDI devices (such as a MIDI pedal board), you can use this to control various aspects of the EigenD software.

In Pico Factory Setup 1, within the Instrument/FX control mode, there a new control – below the MIDI output port browse key there is now a MIDI input port browse key, which will display a list of MIDI devices as per the MIDI output port browse view.

In the Alpha and Tau Factory Setups, within the Advanced MIDI Out 1 control mode there is a new MIDI input browse key, which will display a list of MIDI devices as per the MIDI output port browse view. This is located on the key to the right of the MIDI output port browse key.

Once you have selected the desired device from the Browser, you will need to configure your hardware MIDI device to produce MIDI note number information.

Refer to the MIDI Implementation Chart for a table that describes the list of actions that are triggered by corresponding MIDI note numbers.